Dear friends,
This is a general question which pop up in my mind when I'm working as a Hardware Design Engineer. I would like to know your...
37 results in 0.0223 seconds.
-
Advantage of making own hardware without using development boards ?
-
How can we change LDO bypassed to LDO enabled in iMAX6Q ?
Hi All,
My custom hardware is based on i.MAX6Q processor and 800MHz Alliance memory.
1) According to following table... -
Kulunu commented on robertferanec's to What is the suitable oscilloscope for PCIE and DDR 3 memory troubleshooting ?in OtherDear Robert,
Thank you for your feedback.
Could you please give me more information about this ?
"(I... -
Kulunu commented on robertferanec's to What is the suitable oscilloscope for PCIE and DDR 3 memory troubleshooting ?in OtherHi Robert,
Dear Robert,
Thank you very much for your feedback.
This forum helped me to shear lot of information... -
Hi Robert
Here I have attached NXP hardware design checking list. Look schematic tab in excel sheet and look PCIe-II section and there... -
Kulunu started a topic What is the suitable oscilloscope for PCIE and DDR 3 memory troubleshooting ?in OtherWhat is the suitable oscilloscope for PCIE and DDR 3 memory troubleshooting ?
Dear All,
I could figure out the reason for some of the custom hardware designs are not working due to discontinuity of the PCIE high speed... -
Why doesn't use PCIE Gen 1 recommendation in Rex boards ?
Hi All,
When I go through in Hardware design check list I could see following. (NXP PCIE recommendation) / (Look NXP PCIE recommendation... -
Dear Robert,
Could you please suggest me a company which can do hardware debug using environment chamber ? I'm in Sri Lanka(Asia) it is quiet... -
Dependency of tCL and tCWL values on custom hardware performance ?
Hi All,
My custom hardware is based on i.MX6Q processor and 800MHz Alliance DDR3 memory AS4C256M16D3A-12BCN.Design is most related to... -
Hi Robert,
Thank you very much Robert, I appreciate your help.
Regards,
Kulunu -
Dear Robert,
Could you please suggest me any type of low cost environment chamber which can do these testings ? And where can I buy via online.... -
Hi Robert,
I'm using EMMC and SD card. But problem is same. But how this SD card is working for other good boards if the SD card is the problem.... -
Dear Robert,
Thank you for your feedback. Hear I have attached stressapp test results of 4 boards. I ran 12 hours and I didn't get any error...Leave a comment:
-
Unexpected behavior of custom hardware design
Hi All,
I have done DDR memory calibration for my imx6q custom hardware design using NXP stress tester version 2.9 in ambient temperature... -
Do we need to control impedance of CAN BUS ?
Hi All,
Hi Robert,
My hardware design is most similar to imx Open Rex design development board and I have included CAN BUS port...
Leave a comment: