35 results in 0.0362 seconds.
-
Yeah qdrives , You are exactly, Correct. It worked too. I have set the arc approximation to 0 mil by entering 0.0001 mil which automatically eliminated... -
Hi All,
I am happy to hear your different suggestions.
Actually copper to track Clearance is getting adjusted based on my value...Leave a comment:
-
robertferanec, By measuring air gap also i am getting different clearance of what i set in altium.
qdrives rules were enabled,
...Leave a comment:
-
Coplanar Waveguide - Gnd Polygon to Track width Clearance
Hi All,
I have to set the Gnd Polygon to Impedance track clearance as 5.8mil for Coplanar Waveguide Impedance Matching. But alitum is not... -
coffe63 Please unlock footrprint primitvies and do your changes and then don't forget to lock it again.
...Leave a comment:
-
Haiderabidi444 This may happen due to enabling unconnected pins in rules or you may enabled incomplete connection check in unrouted rules.
...Leave a comment:
-
HI margo20 , You have to create the Extruded 3D body with Vacant area is sufficient for another body to fit as like below attached.
...Leave a comment:
-
federico.massimi If the gap of the differential pair is outside of the tolerance of the primary gap, then the pair is uncoupled.
If the amount of...Last edited by Lakshamana Balakrishnan; 03-25-2022, 04:00 AM.Leave a comment:
-
Hi usernamezzz ,
as qdrives method is very good one. I have different solution also please try if you need.
You may use to Place--Embedded...Leave a comment:
-
Roibert If you create a component with net-tie component property in schlib as well as pcblib, alitum will not show error for shorting two different...Leave a comment:
-
HI mulfycrowh , If you need to control the soldermask you better apply "solderexpansion" rule to that either component or component class to...Leave a comment:
-
qdrives your document is wonderful. By the way, that calculator helps us to determine the Area Ratio of the Solder Paste. Please refer the below picture...
Leave a comment:
-
Leave a comment:
-
Wyku Cheers!
For Netlist sync, You try to sync it with schdoc again if you have or else try the method of Importing netlist into Pcbdoc...Leave a comment:
-
Yes qdrives , Your idea works for me. ThanksLeave a comment:
Leave a comment: