...
31 results in 0.0121 seconds.
-
coffe63 Please unlock footrprint primitvies and do your changes and then don't forget to lock it again.
... -
Haiderabidi444 This may happen due to enabling unconnected pins in rules or you may enabled incomplete connection check in unrouted rules.
...Leave a comment:
-
HI margo20 , You have to create the Extruded 3D body with Vacant area is sufficient for another body to fit as like below attached.
...Leave a comment:
-
federico.massimi If the gap of the differential pair is outside of the tolerance of the primary gap, then the pair is uncoupled.
If the amount of...Last edited by Lakshamana Balakrishnan; 03-25-2022, 04:00 AM.Leave a comment:
-
Hi usernamezzz ,
as qdrives method is very good one. I have different solution also please try if you need.
You may use to Place--Embedded...Leave a comment:
-
Roibert If you create a component with net-tie component property in schlib as well as pcblib, alitum will not show error for shorting two different...Leave a comment:
-
HI mulfycrowh , If you need to control the soldermask you better apply "solderexpansion" rule to that either component or component class to...Leave a comment:
-
qdrives your document is wonderful. By the way, that calculator helps us to determine the Area Ratio of the Solder Paste. Please refer the below picture...
Leave a comment:
-
Leave a comment:
-
Wyku Cheers!
For Netlist sync, You try to sync it with schdoc again if you have or else try the method of Importing netlist into Pcbdoc...Leave a comment:
-
Yes qdrives , Your idea works for me. ThanksLeave a comment:
-
Wyku Please give a try with Reverse engineering from Allegro Gerber into Altium Camtastic file and then convert to Altium Pcb. I suggest this method...Leave a comment:
-
Wyku You better try once a fresh start with below video. It may help you.
https://youtu.be/LhSN76oEucgLeave a comment:
-
I can't understand your question? Breif please?Leave a comment:
-
Wyku , IF copper only be the problem You can extract dxf from allegro as copper layers (including tracks,polygons only) and import into altium to get...Leave a comment:
Leave a comment: