It also works with other property names:
"Source Part=CAPACITOR*"
or
"Value=0.1uF"
The content of the...
10 results in 0.0086 seconds.
-
Found it: :-)
To search for all parts with references containing R and followed by any number between 1 and 9999, use the search string Part...Leave a comment:
-
Selection of specific parts in schematic
Hi Gents!
How can I select all resistors in a schmatic at once?
I can select them one-by-one with LMB+Ctrl, and then use RMB ->... -
Robert creates in both software packages his own symbols and footprints. Its part of the course to show you how to do it. Of course you can use in both...Last edited by joe_ls; 05-20-2018, 08:28 AM.Leave a comment:
-
Shortcuts and FuncKeys for beginners
Some novice OrCAD/Allegro/Capture users may find this helpful ...
The attached PDF OrCAD_Capture_Shortcuts.pdf lists all shortcuts Robert...Last edited by joe_ls; 05-16-2018, 08:12 AM. -
Found a paper called "Effectiveness of PCB Perimeter Via Fencing":
[...] The rule of thumb that a stub starts to become reactive...Leave a comment:
-
Hi Robert
Thank you for clarification.
Are there some documents or books you recommend about VIA fencing?
Cheers
...Leave a comment:
-
5v plane and 20h-rule
Hi
During the ISL6235A power supply project I created the 5V plane as it was mentioned in the course.
This +5V plane is on L4, two...Last edited by joe_ls; 05-03-2018, 04:18 PM. -
Thank you, Robert.
It's always interesting to see other people work habits and pick up some good advice. Especially from experienced pcb design...Leave a comment:
-
Schematic drawing without consideration of pcb
Hi Gents,
just a question, but I don't want to create a tempest in a teapot. And I don't want a pro/con discussion about pcb-software, it's...
Leave a comment: