Announcement

Collapse
No announcement yet.

Problem in making gerber file in Allegro 17.2

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • robertferanec
    replied
    I wish that. If you could please inform me. Thank you so much
    - I am not sure what you mean. I meant, if I was in your situation I would try to design a simple board or I would try to open different design to see if the problem is project specific or if it is something with installation or settings. Hope this helps.

    Leave a comment:


  • Armin
    replied
    Originally posted by robertferanec View Post
    Hmm, I do not know Maybe I would try to design a very simple board to see if there is still the problem or I would open a different 17.2 design and check if there is the problem.
    I wish that. If you could please inform me. Thank you so much

    Leave a comment:


  • robertferanec
    replied
    Hmm, I do not know Maybe I would try to design a very simple board to see if there is still the problem or I would open a different 17.2 design and check if there is the problem.

    Leave a comment:


  • Armin
    replied
    Originally posted by robertferanec View Post
    I think, in 17.2, for board outline you need to use Design Outline layer. Maybe that could be the problem?
    I added Both "CUTOUT" and "Design_outline" to my films but unfortunately still I have the warning.

    Leave a comment:


  • robertferanec
    replied
    No I have not used hole inside the board also I used Outline for around board.
    I think, in 17.2, for board outline you need to use Design Outline layer. Maybe that could be the problem?

    Leave a comment:


  • Armin
    replied
    [QUOTE=robertferanec;n10532]
    - Maybe this will help? https://community.cadence.com/cadenc...ngle-not-found

    I saw that link before. Oldmouldy told "It's a warning message that can be safely ignored. " I think I can ignore this error.

    Originally posted by robertferanec View Post
    - I am not sure. Do you have a hole inside PCB which is expected to be marked as cutout? Outline is usually around board, cutouts are usually holes inside PCB.
    No I have not used hole inside the board also I used Outline for around board. I think there is some differences between 16.6 and 17.2. Is it right?

    Leave a comment:


  • robertferanec
    replied
    Photoplot outline rectangle not found; using drawing extents.
    - Maybe this will help? https://community.cadence.com/cadenc...ngle-not-found

    In 17.2 when I want to make gerber gives me a warning to use Cutout instead of Outline.
    - I am not sure. Do you have a hole inside PCB which is expected to be marked as cutout? Outline is usually around board, cutouts are usually holes inside PCB.

    Leave a comment:


  • Armin
    started a topic Problem in making gerber file in Allegro 17.2

    Problem in making gerber file in Allegro 17.2

    Hi
    I have 2 question in making gerber
    I want to make gerber file in Allegro 17.2 but when I want to create artwork I 'll face with this error:
    Photoplot outline rectangle not found; using drawing extents.
    I didn't face with this error before in 16.6.
    What can I do for resolving this issue?

    Another question:
    What is the differences between Outline layer and Cutout layer? In 17.2 when I want to make gerber gives me a warning to use Cutout instead of Outline. I used always the Outline layer in 16.6 and have not any problem before. is it important to be Cutout?
Working...
X